Attic to R-30, walls to R-13

Insulation Rebates in Burbank

Burbank Water and Power rebates both attic and wall insulation, and the wall rebate is rare among Los Angeles-area utilities. BWP does not publish a per-square-foot figure on its page, so this page sets out the rules and what to ask before you book a contractor.

On this page
  1. What Burbank Water and Power rebates
  2. Why the 24-inch clearance rule matters
  3. Walls are the unusual part
  4. Your utility: Burbank Water and Power
  5. Comfort first, then size the system
  6. Federal money
  7. How to claim the BWP rebate
  8. Common questions
  9. What to do next
  10. Compare top-rated installers in Burbank
← Back to Burbank rebate hub Heat Pump Rebates in Burbank Water Heater Rebates in Burbank EV Charger Rebates in Burbank Smart Thermostat Rebates in Burbank Appliance Rebates in Burbank

What Burbank Water and Power rebates

These rules come from BWP's residential rebates page, which we read on October 2, 2026. BWP says amounts are on the application and that new construction does not qualify.

Open

Attic insulation

Set on application

Must reach R-30, or R-19 if the attic has less than 24 inches of clearance. Higher incentive for low-income customers and certain affordable housing providers.

Open

Wall insulation

Set on application

Existing walls must be uninsulated, and the new insulation must be at least R-13. Higher incentive for low-income customers.

Open

Documents

Square footage

BWP needs supporting documentation that shows the total square footage insulated.

What we could not confirm

BWP's page names both rebates and their R-value rules but sends you to a downloadable application for the amounts. We could not read a per-square-foot figure, so we do not quote one. Download the application first and see the rate before you sign a contract.

Why the 24-inch clearance rule matters

BWP sets the attic target at R-30, but drops it to R-19 if the attic has less than 24 inches of clearance. Many older Burbank homes have low or sloped attics where thick insulation does not fit. If yours is one of them, ask the contractor to measure the clearance and to say in writing which target applies. Writing it down protects you when BWP reviews the application, since the finished R-value has to match.

Walls are the unusual part

Wall insulation is hard to retrofit, and many utilities skip it. BWP rebates it only where existing walls are uninsulated, to at least R-13. Blown-in insulation through small holes is the usual method, and a contractor should check for obstructions and wiring first. Pasadena's rebate covers ceilings only (Pasadena insulation rebates), so Burbank is the better fit if you want to insulate walls too.

Your utility: Burbank Water and Power

BWP is the city's own utility. It runs this rebate separately from its Electrify Your Home program, so insulation does not need a gas appliance to be replaced. The call center is (818) 238-3700, and the application goes in by mail or at the office at 164 W. Magnolia Boulevard. BWP says rebates arrive 6 to 8 weeks after it receives your application.

Comfort first, then size the system

Burbank's average January low over 2015 to 2024 was 8.4°C, so winters are mild and the main benefit of insulation here is in summer, when a hot attic pushes heat into the rooms below. If you plan a heat pump, insulate the attic first and let the installer size the system afterward. Ducts in an uninsulated attic lose a lot of heating and cooling, so ask about sealing them in the same visit.

Before any insulation goes in, ask the contractor to look for air leaks around attic hatches, light fixtures and wiring holes, and to seal them first. Insulation slows heat, but it does not stop moving air, so a sealed attic with R-30 on top works far better than R-30 laid over open gaps.

Federal money

The federal 25C and 25D tax credits ended for spending after December 31, 2025. BWP's rebate is the main incentive for insulation in Burbank today.

How to claim the BWP rebate

  1. Check that BWP is your electric utility, and that the home is not new construction.
  2. Download BWP's application and read the amounts and the R-value rules.
  3. Have a contractor measure the attic clearance and the existing wall insulation.
  4. After the work, collect the invoice and documentation of total square footage and the final R-value.
  5. Mail the application, or drop it off at 164 W. Magnolia Boulevard.
  6. BWP says the rebate arrives 6 to 8 weeks after it receives the application.

Common questions

Does BWP rebate wall insulation?

Yes, for existing walls that are uninsulated, with new insulation of at least R-13.

What R-value do I need in the attic?

R-30, or R-19 if the attic has less than 24 inches of clearance.

How much does the insulation rebate pay?

BWP sets the amount on the application and does not publish a per-square-foot figure on its page.

Is there a higher rebate for low-income customers?

Yes. BWP offers a higher incentive for low-income customers and certain affordable housing providers. Enroll in BUSS or Lifeline before you apply.

Does new construction qualify?

No. BWP says new construction does not qualify.

What to do next

See BWP's residential rebates page for the application, or compare all Burbank offers on our Burbank hub.

By Sam Menard. Sources, last read October 2, 2026: BWP Electrify Your Home rebates, BWP residential rebates, BWP residential EV charging station rebate. All Burbank rebates → Every Burbank Water and Power rebate →

Compare top-rated installers in Burbank

Free for homeowners. We rank local companies by their Google reviews, weighted so many good reviews beat a handful. How we rank.

Top-rated insulation installers in Burbank →3 local companies ranked by 461 Google reviews. Top picks: Burbank Top Insulation Service, Atticare, Viking Insulation, LLC.

Insulation rebates in every region: compare insulation rebates by province and state, with a BC attic calculator.

From Sam

Get the monthly rebate update

Once a month: new and changing rebate programs across every province and state we cover, plus what's new in heat pumps, solar and batteries. Short, sourced, no marketing.

No spam, ever. Unsubscribe anytime.

See my rebates and installers